Posted by JDGnut on March 25, 2013 at 18:02:14 from (64.134.177.138):
In Reply to: Antifreeze in cylinder posted by Johndeereman on March 25, 2013 at 16:45:56:
Take the manifold off, spark plugs out and plug the bolt holes for the manifold.. Take the upper and lower pipes off.. (or water manifold)Pressurize the head and block.. and Look in the intake and exhaust ports and in the cylinders.. If you have a scope, even better..
I just put a plate over the lower.. and built a fitting to put in the upper... and then set a pressure regulator to about 10 psi..
This post was edited by JDGnut at 18:02:48 03/25/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.