Posted by NeedMoreRedPower on January 30, 2013 at 17:12:27 from (184.108.40.206):
Thinking about building a really big cubic inch "M" farmall. I have seen and heard all about the 4.375"X7" making about 120 horses. But need more, Just how big can you actually build, is 650+ cubes possible or just a dream. I dont see have you could swing anything bigger then 7'5" and not hit the oil gallery. And when you bore out past the original cast bore it looks like your going to lose all the strength out of the deck and would smash the deck when you tighted the head down. Can you actually weld in a a 4.75 sleeve out of a JD and hard block and get it work? Just possibly dreaming, but is it possible and still work. Thanks
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.