Posted by M Hoffmann on January 29, 2013 at 18:23:03 from (22.214.171.124):
My daughter bought a Farmall H, building it for her to pull. Engine tore down thinking of installing 350 sleeves and pistons, has a 8043DC head is that ok verses the 8043DD head, it is a 1952 with the small crank jurnals already ground .010 if I need to go .020 will it be ok.Camshaft # is 43962DB but going to send it out to get ground. Rods have large piston pins will the pin adaptors work ok or should I find different rods from a 350. Thanks for any help Mike
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.