Posted by mEl on December 31, 2012 at 04:44:58 from (22.214.171.124):
In Reply to: m pistons in a d posted by 1948 mm on December 30, 2012 at 17:44:12:
Quoting Removed, click Modern View to see
Just a bit of info to help you along in your search, The D engine has a 5.5 stroke crank, a 10.75 " centerline rod length and a 16" deck height block. A little math shows the piston compression height will need to be 2.5" for a 16" deck height. thats just the math.
You should be fine if you can find a piston with that compression height. IIRC there are M pistons with a tall compression height, maybe even more than 2.5.
OH, the D series use a 1.233 wrist pin that clamps in the rod with a clamp bolt so your piston choice would be to a piston that can be adapted to that pin size as the rod end would have to be reworked to a different pin size and pin securiing method.
I have successfully put a clamp bolt in the rod, tightened it enough to not close the bore and welded the split and bolt to one piece then had the rod small end machined for a 1.250 pin, slip fit no bushing and it was fine for years so there are possibilities if you are not afraid to think "outside the box.
Good luck, There's lots of power in that engine and not to hard to get out, the engine will also respond nicely to more valve lift and a good cam is some of the cheapest power you can get.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.