Posted by D Slater on December 24, 2012 at 15:24:45 from (22.214.171.124):
In Reply to: Governors posted by Dave Thompson jr on December 24, 2012 at 13:45:25:
Sounds high, different things on some of those compared to a IH were. Ball bearings in the fork, hiem joints on the throttle link. Fork with a closer sized spring hole and also the in the lever for the other end of the spring. Different throttle tube and shaft. If I remember correct the fork spring hole is located so the spring has a little different leverage pulling the fork. Weights are pinned different than a IH. May be something I forgot. Could be argued if some of the things in those governors helped or not over a IH. M&W also sold a two weight governor at one time.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.