LKLKLKLKLKLK I can read part numbers just fine, 4229 is the one I like. The point I was trying to make was that rectangle port heads shouldent be allowed in the stock class on a U or UB ect. As you can see I like HD800s but I feel they belong in the open div5 clases. Im by no means the first to put an HD800 in a gvi or 95 I was just showing you what kind of tractors I like to pull and that mabie Im not a compleat idot when it comes to molines as you would like to think I am. I posted a couple of pictures of my projects and I would like it if you could share some photos of what you pull. I also have a single front red face U single block that I pull with that has a head casting number of KE282E small chambers and 14mm plugs. Nobody I have talked to seems to know anything about it. Your a moline casting number expert mabie you can help me out. thank you for all of your words of wisdom thus far, its always nice to share info with a fellow moline puller.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.