Posted by Mopower on September 18, 2012 at 08:39:18 from (22.214.171.124):
In Reply to: 403 in a uts posted by mmkid on September 17, 2012 at 19:21:08:
If you are using a complete 403 engine in a U, you use: U flywheel 403 ring gear 403 starter
The tranny bell may require a little clearance touch up to let the larger ring gear fit inside. You should be able to heat up the U ring gear, tap it off the flywheel, heat up the 403 ring gear, tap it on in its place. The reason for the larger ring gear is that the G starter sits a little farther out than the U.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.