Posted by molineubspecial on September 17, 2012 at 19:29:14 from (22.214.171.124):
In Reply to: 403 in a uts posted by mmkid on September 17, 2012 at 19:21:08:
What do you mean not right on? The u and g bolt hole pattern and crankcase should match rite up in your u tractor assuming you are using a u flywheel and starter if you want to use the 403 starter and flywheel you will have to grind out the housing on the tractor to exceptthe large starter and flywheel
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.