Tractor Pulling Discussion Board |
Re: weld on axle plates
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by joe on December 25, 2002 at 04:46:29 from (24.189.245.227):
In Reply to: weld on axle plates posted by Dave on December 23, 2002 at 17:51:17:
these plates are easy to make if you have a lathe or know someone who does. cut a circle out of a plate of steel with a torch . chuck up the circle and bore a hole in the center, while its in the lathe touch the tool on the circle the radius of the bolt pattern of the rim. the after takeing it out put a center punch on the cicle and layout the hole eqully spaced with a divider and drill and tap them. if you do this you can save money but you also will see that the prices people ask is not that high.PS do not cool of the circles after touching with water.
Follow Ups:
Home
| Forums
Today's Featured Article -
Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|