Posted by Axlerod on September 27, 2008 at 21:52:23 from (70.41.11.118):
In Reply to: Re: Pulling hitch posted by kendak on September 24, 2008 at 17:20:19:
Hey Dummy, Have you ever seen a pintle hitch attached to a huge dump truck that is capable of pulling a 40-50,000lbs trailer? It's attached with 4 (tiny) grade 8 bolts. That pulling hitch looks like a fine setup from where I'm sitting. The top bolts aren't going to take much of the load but the 4-6 on the bottom will handle it just fine.
Drew is correct on 100 percent of the things he has been trying to educate your ignorant bone head on. You are flat wrong on pretty much everything thus far but I'm sure you've become accustomed to that over the years.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.