Posted by Butch(OH) on April 10, 2014 at 05:16:32 from (66.192.33.38):
In Reply to: Mp 170 as a sealer posted by South Tipp on April 06, 2014 at 09:03:53:
The P sheets for the old high end DP40 epoxy primer listed a mix ratio for using it as a sealer coat, as I remember 10% maximum and was same reducer we used with Delstar top coats. The newer lead free version DP40LP does not, or did not list same usage. I have not looked recently since I switched over to MP170. While it is not listed on the P-sheet I have reduced MP 170 in a similar manner using MR180 series reducers with great results. You must be careful to not get carried away with the reducer, I never go over 1 part in 10.
The worries with recoating epoxy primers are not in doing it too quick but in waiting too long. In reality there is no idle wait time between priming with 170 and top coat. By the time you get your primer gun rinsed and a batch of top coat mixed and in a gun you can right at applying it. For best adhesion on sheet metal and in hot weather you need to pay very close attention to the P-sheet recoat window however there is no need for panic if the job goes a bit long, meaning a day. For castings you can stretch it out a few days and will have zero problems. Cool weather also allows for stretching it some. In any case if it has set for weeks you dont recoat it without prep work.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.