Some years ago (2006) I did a cost comparison of PPG's "economy grade" OMNI MTK single stage urethane and PPG's "premium grade" Concept DCC single stage urethane. The mix ratios of the two products are different as are the costs and the costs of all additives. I did the comparison on an RTS (ready-to-spray) basis. One quart of MTK RTS was $19.82 and one quart of DCC RTS was $59.93. I assumed that any leftover reducer was not wasted and could be utilized at other times. That makes DCC about three times as expensive as MTK. My past experience using both MTK and DCC is that DCC is quite obviously a higher solids product and covers better than the MTK. While I use three coats of MTK, I only need two coats with DCC. Incorporating the coverage difference into the RTS cost difference, concludes that topcoating any object that requires one quart of RTS material per coat will cost $120 using DCC and $60 using MTK. By that analysis, the DCC costs twice as much to cover the same object as the MTK.
My personal opinion is that for the DIY that only paints on an occasional basis and does not count his time as money, then the DCC is not worth twice the cost, although one could weigh the value of the extra risk of screwing something up during an additional coat. On the other hand, for someone whose time is money and making a profit is the incentive, then the premium DCC might well be worth the extra cost. Plus if one is experienced enough to be able to get adequate coverage in a single coat of DCC, then the cost is awash and the decision is an easy one to go with the premium product.
I think that even B would agree that the PPG's "economy" epoxy primer (OMNI MP-170) is just as good at a far less cost than PPG's "premium" epoxy primer (DPLF). I used to use the premium DP (before they took the lead out and called it DPLF) and always found it to be an outstanding product. Quite some time ago however, I moved to MP-170 because of cost. After using that for a number of years, I see no reason at all to go back to DLPF, at least for a DIY doing his own work where there are no warranty issues to consider.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.