Posted by CNKS on December 07, 2012 at 07:03:58 from (216.144.104.128):
In Reply to: Re: Grit posted by RTR on December 06, 2012 at 08:31:14:
PPG Omni epoxy can can have surfacer or topcoat applied after 30 minutes. Surfacer over the epoxy I usually wait until the next day to sand, although it can be done the same day. The Omni MP 182 surfacer uses hardener, thus it is sandable very soon. Up to you but you are wasting time with the products you are using. Use quality products from PPG, DuPont, Martin Senour, etc and follow the spec sheet. They ALWAYS work as long as you follow insructions. Yes they are expensive, and some of them require supplied air to protect your lungs, but you get what you pay for. CaseIH does not sell acrylic enamel, it is an acrylic modified alkyd enamel, it's ok but not as good as urethane.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Rebuilt Injection pump for J D 1010. Call or text for pictures or more imformation.free shipping.U.S. No core charge
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.