Posted by SDE on July 27, 2012 at 21:54:15 from (184.108.40.206):
I have hung some used aluminum sideing in my shop. I also just bought a used HVLP spray gun at an auction. I would like to put a fresh coat of white paint on this sideing before I return all the junk to its rightful places. I stopped at the Hardware store and the clerk did not give me any answers that inspired any confidence at all. The gun has a 1.4cm tip on it. I have some oil based enamel paint, But I am going to asume that it will need to be thinned in order to get it to work in this gun. I doubt that thinning it by just 10% will be enough to get it to spray. Will Latex work, if thinned enough. Clerk said so, But I don't think so. Is automative paint the only real solution? Thank you Steve
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.