Posted by Alan8n on July 24, 2012 at 10:16:39 from (47.23.113.234):
I am going to do small scale sandblasting on misc parts of my tractor to remove old paint / mild rust. Some are cast iron some are steel, some are sheet metal. Settled on using Balck Beauty / Black Diamond but can't figure out what grit to use. Local store only has 20-40 and I am told that it may be "too aggressive " and I should use 30-60. I typically use the MP170 Epoxy primer (2 coats) and topcoat of various manufacturers with hardener( 2-3 coats). I am not sure what "too aggressive" means too me. Does it mean I will get poor coverage, and need to use more primer / paint... or does it mean that I will just be taking off more material then I should ....or...??? Thanks....Alan
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.