Posted by soundguy on July 11, 2012 at 11:53:19 from (220.127.116.11):
In Reply to: 8n wheel repair posted by Patrick Clegorne on July 05, 2012 at 19:24:59:
common to weld a rim blank onto an old center.
remove the old rim as you can. grinder.. sawsall,, cutoff wheel.. plasma cutter.. torch.
I done em all.. torch was the easiest.. then hit it with a grinder a bit to clean up
lay flat and use blocks to prop the center to get it level in new rim.. use other rim as a measurement guide. tack in.. then remeasure.. and check for true all around.. then weld her in.. grind.. paint up and remount and go.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.