Posted by geoff gwisdala on June 10, 2012 at 12:09:13 from (22.214.171.124):
In Reply to: prep for paint posted by Jr. Roby on June 10, 2012 at 09:56:06:
ive done a couple of tractors that were really caked with dirt, grime and old oil. i found the best way is to just dissassemble, clean and paint and reassemble. done right the first time you will have much better looking paint job. for some areas where dissambly isnt feasible a can of brake clean and a piece of scotchbrite pad attatched to an old screwdriver works well to rough up the surface for paint/primer adhesion
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.