Posted by CNKS on April 12, 2012 at 07:28:26 from (216.144.104.128):
In Reply to: Acid wash or Picklex posted by Rowcrop 66 on April 12, 2012 at 07:00:52:
As I have said many times before, Picklex 20, if whatever you are painting is down to bare metal. It is used as a protectant, or for minor rust conversion. If you are going to sand and paint right away, you don't need anything, as long as you have mechanically gotten rid of the rust in the pits. I live in a dry climate and have no need for anything. However we have had about 3.5 inches of rain in the last month, humidity has been unusally high. I have two 38 inch rims I sand blasted about 2 months ago sitting against my overhead door, where humid air and any moisture can get inside. There is no rust at all on those rims or on any of the other parts I blasted sitting on shelves. I get flash rust instantly if outside, but none inside. You need to be careful and take care of your bare metal, but it is not an emergency unless you have to let it sit for a long period of time. In a 24 hour a day humid climate what I do may not work. If you use Picklex 20, there is no need for anything stronger, and you do not need to wash it off. Prior to painting just scuff off any white residue followed by wax and grease remover, it works every time. BUT, if you cannot get rust mechanically out of the pits, you still use Picklex 20 and then use the scuffing and wax and grease remover. No need at all for acid wash, Picklex replaces that and works just as good. Picklex is expensive, but does not need to applied heavily and a little goes a long way.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.