Posted by WD9ER on March 05, 2012 at 11:36:01 from (65.127.84.74):
So I’ve got all the grease, gunk, dirt, etc removed from my WD-9. I’ve treated most of the fabricated parts with rust inhibitor, but not the cast parts as the consensus here seems to be that it will eventually cause paint lifting. Now I am putting pieces back together in preparation for primer. Being I have never painted cast surfaces before, I am wondering what the best way to clean the surface prior to spraying. Normally, I would just wipe everything clean with a wax & grease remover and spray. Can I use a spray bottle of wax and greaser remover to reach those hard to reach places? It seems like with the cast surface, the rag never comes back completely clean. Should I tack cloth it also?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.