Oliver, Cletrac, Co-op & Cockshutt Tractors Discussion Board |
Re: Oliver 242 disc/harrow carriage bearing?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by IanC on October 16, 2006 at 11:04:33 from (75.35.86.233):
In Reply to: Oliver 242 disc/harrow carriage bearing? posted by rpmx5t on October 15, 2006 at 09:32:28:
If you are talking about the DISC GANG bearing the Oliver/White part number was 237092B, the Timkin number is W208PPB7. The top 3 bolts in each set of flanges hold the gang to the standards. Lower the disc to the ground, take out the bolts, then lift the disc. As I reacll the gang bolt gets torqued to 400 ft/lbs.
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|