Posted by Zach Scherf on April 06, 2014 at 15:15:29 from (184.108.40.206):
I put a white multi fuel in the white 2-150 we have. Swap was hard but I got it done and looks good. Only one problem, the engine took a lot to bleed it. Once I finally got it bleed it started at 1500 rpm and I let it run for about ten minutes. Then it suddenly cut out. After topping all the oils off I started it again at the same throttle, but, as before it took a hot of ether then ran fine for another few mins then it cut out again. It won"t run below 1500 rpm, it dies. I know I have a fuel problem, any ideas? I have good flow to the injector, it ran good before sitting a year, I already installed a new fuel pump and fuel filters, please give me ideas of what to check next!
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.