Posted by chucksoliver77 on February 23, 2014 at 07:55:56 from (184.108.40.206):
In Reply to: 1550 engine? posted by B A Star on February 22, 2014 at 11:28:15:
Roger, I have had the 3 3/4 overbore in my 77 [basically the same engine] for more than 30 years with no problems. They sell those kits on here and told me they are made in the U.S.A. Just take a hammer and a block of wood and drive the sleeves out from the bottom. Chuck
This post was edited by chucksoliver77 at 08:05:34 02/23/14.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.