Posted by ollie770 on July 10, 2013 at 08:48:00 from (188.8.131.52):
I have oil leaking out the left rockshaft on the hydraulic where the upper arms of the 3 pt. attach on my 1850. I looked up and found part 107744A as the seal for that and crossed it to a Timken 415960 from the parts store. Is this seal replaceable from the outside - ie remove fender, remove snap ring and upper arm from shaft, and then pull the seal and install the new one? Just thought I would check and see who has done one before I tear into it. Thanks!
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.