Posted by Massey farmer on May 21, 2013 at 18:23:06 from (18.104.22.168):
90 percent retired, a few weeks ago I asked a question about my 1800 Oliver 3 pt and hydraulic lever problem. I poped the hydralectric cover off and found all my problems so thanks a lot. The lever problem was the washer that acts as a key on the shaft that runs to the control spools had sheered and the lever was not moving the spools like it should. The 3 pt problem was in the servo valve. I took it completely apart to clean and make sure all the balls were free and seating well. When I took one spring and ball out I found a piece of a broken spring in there. When I put it all together everything works great. Thanks for answering my posts.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.