Posted by J. Schwiebert on February 24, 2013 at 13:26:04 from (209.143.54.246):
In Reply to: Wristpin 60 posted by Bob Frazier on February 24, 2013 at 11:56:02:
Well I am sure you have heard of later Oliver engines that used the 2 wrist pin bushings per rod working out and causing major problems. The 60 used the same set up. With that being said the man I am helping son is redoing a 60 engine as we speak. The machine shop installed new bushings and honed them to fit. It now has one piece bushings. Now in reguard to the wrist pins, he could use his old ones. I don't have my book handy to check pin diameter, but a lot of engines used common pin sizes. I can check after while and then I don't know if it will cross over to a pin that is still available but I can get you some numbers. My 2 cents worth. J.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Rebuilt Injection pump for J D 1010. Call or text for pictures or more imformation.free shipping.U.S. No core charge
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.