Posted by J. Schwiebert on February 10, 2013 at 13:03:06 from (209.143.54.246):
In Reply to: 88 standard posted by rod in nebraska on February 10, 2013 at 12:48:12:
Well the units will fit right on there. Do any of the tractors have a mechanical lift? If so the top shaft in the transmission will need to be sawed off or changed from the doner tractors. The K-914 shift lever socket will need to be changed as well. You will need the K-914A socket from the tractors that have the hydraulic units. If you add the hydraulics, and it was me unless you know the history of the hydraulic units I would completely disassemble them and clean then up and inspect for wear. Also remember the Fleetline hydraulic units were different from the Super seris if looks and the correct police are important to you.Also if you have the Fleetline units you should also grab the electrical switches and wiring harness.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.