Posted by Tom Rowe-Drake on January 16, 2013 at 16:25:42 from (108.12.194.206):
In Reply to: sleeve installation posted by sdc eastern ia on January 16, 2013 at 14:47:01:
When you get that sleeve out take the orings off and set the sleeve back in the hole. It should NOT hangup and you can turn it in place. If not you need to correct the interfearance. Then, with the sleeve out look at the ramp on the bottom of the block where the orings start to get tight. Look for spots of skale/rust/flakes that will damage and or pinch the oring "too" soon as the sleeve gets close to seating.Chip off and sand/clean. Reinstall the orings dry to the sleeve, then use a icepick to realign the oring , I rotate the icepick 5 or 6 times under the oring . this untwists it. Now soap it up and happy sleeving.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.