Posted by oliver1850t on December 23, 2012 at 09:04:42 from (184.108.40.206):
In Reply to: 2-105/2-135 turbo posted by 1850Dpuller on December 22, 2012 at 17:37:01:
Get yourself an H1 Holset off an older Dodge truck. It will work perfect for what you need. You will have to make a flange for the exhaust. The bolt pattern is larger on the holset. Far better turbo than the garrett. If you plan on keeping the original engine, find some used 2-105 pistons and connecting rods the are stronger, fully pressurized, and can take a lot more heat. I have melted a couple of original 1850 pistons doing what u are planning to do.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.