Posted by J. Schwiebert on November 22, 2012 at 07:29:42 from (209.143.33.150):
In Reply to: Re: 88governor posted by d88 on November 22, 2012 at 06:19:37:
How much wear is on the gear? Before the days of the new style bushings we had some tractors with high hours running around that had two of the K 289 thrust washers to take up some of that wear. How much wear is on the pivot edge of the weights and in the pin area? Probably 90% of the governor arms need to have the holes brazed shut and new holes drilled in them because of wear in that area as well. The same is true for worn linkage. Is this a farm tractor or a pulling tractor? If using for farm work you need 19 active coils on your governor spring
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.