Posted by Matt in the Thumb on November 05, 2012 at 10:09:14 from (64.90.137.2):
In Reply to: plow to plow pics. posted by chucksoliver77 on November 04, 2012 at 19:10:46:
Nice plow! I"d be afraid to get that whole setup out in the dirt. That 77 is physically a whole lot bigger than my Massey 65. My 3241 looks huge on my tractor. Noticed yours is set as a 3x14. That"s how mine was, but it"s too much for my tractor. Working on taking it down to a 3x12. Taking a while to work through rusty hardware painted over a time or 3. Found out mine is missing the third long brace that runs from the top-link hoop down to the backbone, as well as the brace for the rear moldboard. Have to make something up for those. Found some red paint underneath mine when I took it apart. Wonder if it was a Cockshutt from the factory.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Looking 4 set 9 bolt hubs 3 1/8 inch to fit 60 to 4010 jd
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.