Thanks, I was kinda hoping that you had a simple fix! Changing inputs shafts wouldn't be a problem, I have a couple of them laying around, but I hadn't thought about the spacer. What about machining the flywheel to take up some of the space? I don't have a feel for the difference in depth from the single disc to the double, is it 1/2 inch deeper or inches deeper? I have a few inches of radiator fan spacing, so that could actually help fix one problem. PTO shaft length sounds problematic.
On the O/U issue, I'm planning to go with the thinner Kolene steels and the extra frictions set up like in the 2-180 heavy duty. Gonna use overdrive frictions made to carry higher HP than the agco parts. Planning to shim the pressure up. It seems to look good laying in parts on my bench, we'll see how it works once I figure out how to get it bolted in the tractor.
I'll be pretty disappointed if we bolted it all together with the single disc clutch and ripped the center out before I figured out whether or not my O/U modifications were any good.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.