Posted by Don-Wi on September 24, 2012 at 15:57:25 from (22.214.171.124):
In Reply to: 1755 hydraulics posted by young tractor on September 24, 2012 at 05:25:14:
On the back of the valve bank is a screw with a jam nut on it. The one that goes to the hoses you're using is the one you need to adjust. Loosen the nut and turn it in to make it a smoother/slower drop. Out to do the opposite.
Not sure there is much that can be done about the fast raising other than feathering the controls, unless you maybe use a bigger (diameter) cyinder that takes more oil to fill and extend.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.