Posted by OliverNate on September 03, 2012 at 18:45:19 from (18.104.22.168):
In Reply to: oliver 77 posted by pulling kid on September 03, 2012 at 06:47:24:
do you have new plug wires on it? if not maybe your coil wire is bad, also check over your wires for the ignition system. I got a Oliver Hart-Parr 70 that I switch to 12 volt and all I did was switch the polarity on the coil. and haven't had a problem, the coil cracked on me (left ignition on after I ran out of gas) and leaked out some of the oil and it still works just fine.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.