Posted by Jeff in Columbiaville on September 02, 2009 at 10:43:30 from (24.247.196.139):
Hi All,
I got an oliver 1550 with hydralectric and 3pt. when i raise RPM's above 1200 the 3pt raises and lowers ok. Now when I put the rpms at 2200 it raises and lowers at spec 1.5 seconds. My problem is that when I hook up the remote (right side) to my double acting cylinder and raise my NH469 haybine with a 3"x8" cylinder it works fine at first but once I go and start working then it get slower and slower.
I verified that the bleeder is all the way in (the one that you unscrew a few turns for single acting cylinders). I made sure that the restrictors were set ok. So I decided I would check the filter and change the oil. Well the filter wasnt too bad but I ordered a new one. The book says to hook a hose to the drain plug and run the tractor till no more fluid. My drain plug won't come out so in my thinking, I thought "hay use the left remote and just squirt it into a can".
That is where i got confused...
I hooked up a hose and put it into a 5 gallon bucket, started the tractor and fluid started coming out the hose even though the spool is in it's centered position. When I move the spool to the other port the fluid stops and when I move it to the port with the hose, the fluid comes out fast.
Is this normal? I took the cover off and cleaned the spools, the balls all look fine so do the springs, the spools fit tight but slide easy, like the book says. I'm hoping that it is just the fluid is bad but I don't know.
Sorry so long winded but I hope that i filled in enough of the issue for some ideas....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oil Bath Air Filters - by Chris Pratt. Some of us grew up thinking that an air filter was a paper thing that allowed air to pass while trapping dirt particles of a particles of a certain size. What a surprise to open up your first old tractor's air filter case and find a can that appears to be filled with the scrap metal swept from around a machine shop metal lathe. To top that off, you have a cup with oil in it ("why would you want to lubricate your carburetor?"). On closer examination (and some reading in a AC D-14 service manual), I found out that this is a pretty ingenious method of cleaning the air in the tractor's intake tract.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
