Posted by soundguy on January 30, 2014 at 06:12:30 from (108.112.43.86):
In Reply to: Carb swap posted by Tom Jubilee on January 29, 2014 at 17:46:22:
as old said.
if it bolts up.. yeah.. 'probably' fine.
here are the issues you have to look at.
there are 2 5/16 and 2 3/8 spaced studs on carbs.
you have original manifolds made for each size.. and then universal manifolds made for both.
Some have even takent he small manifold and filed out the ears to put the large carb on.
as long as the engine in the 631 ( 134ci ) has not been swapped for a 172 CI with associated manifolds and such.. IE.. should be fine if it bolts.
And yeah. you can run a 172 on a 134 carb and be derated..
find out what carb you have.. and that will tell you the mount size. match up that mount spacing, and then get a carb in that mount spacing for the CI of your engine. which, again, if original.. is 134ci.
and yeah. I have seen lots of stuff swapped.
I have a 950 wearing the small manifold of a 134ci engine..a naa and it's wearing it's carb too! ( it's what i had on hand.. and the 950's carb was shot and manifold broke... )
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.