Im a bit late on your post just so I get it correct as I talked you into a shade tree mechanic. Are you sure there is no oil filter? See photo from Bruce, your tractor is a Ford N right? 1010 NAPA oil filter. You know it is not a screw on one like your car or truck? You did remove all the green liquid in the cylinders? Clean mating surfaces where the head sits on block? DO you have a manual that shows tighting order of head bolts? If not let us know. Stop if you have a doubt on your repair. A lot depends on your head repair. Do as you want but I am a fan of copper spray gasket seal and silicones. For me it is just a way for me to avoid a problem , but that's me do what you want. A lot of guys get by fine without it. I also throw in some builders block into the cooling system to avoid leaks. Have fun.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.