The screw on the left side of the distributor that holds the breaker (points) plate will have to be loose. Take the two bolts out that hold the distributor on and remove it. You can leave the wires attached to the cap, and remove it first. The drive tab on the distributor is offset, so you can't put it back in 180 degrees off. Set it like it is in this pic, then rotate the points plate a little if needed to where the points are JUUUSSSSTTT starting to open. If you can see the gap,it's probably too far. It works better with a test light and power or a meter, to detect them starting open.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.