Posted by Caryc on September 22, 2013 at 17:44:54 from (209.86.226.56):
In Reply to: 2N plug wires posted by TOM N MS on September 22, 2013 at 17:21:06:
TOM N MS said: (quoted from post at 17:21:06 09/22/13) How big of a pain is it to put the ends on?
It's pretty simple to put the ends on. As you can see in the pics, first spray the wire end with WD40 to make it slippery then slide the 90 degree boot on. Next strip the appropriate amount off the wire and put the 90 degree metal clip on.
As you can see in the last pics, I used a crimper for TV coax cable ends. It works very well for spark plug clips. When I crimped the clip, I put the shank end of a 1/8" drill bit in the crimper with the clip to make it a little tighter. It worked very well to put a good crimp on those clips. Then just slide the boot over the metal clip. No explanation really needed for the other ends.
I use that crimper for TV stuff but I actually think it's worth buying the tool just to make up plug wires even if you don't use it for anything else
This post was edited by Caryc at 17:48:33 09/22/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oil Bath Air Filters - by Chris Pratt. Some of us grew up thinking that an air filter was a paper thing that allowed air to pass while trapping dirt particles of a particles of a certain size. What a surprise to open up your first old tractor's air filter case and find a can that appears to be filled with the scrap metal swept from around a machine shop metal lathe. To top that off, you have a cup with oil in it ("why would you want to lubricate your carburetor?"). On closer examination (and some reading in a AC D-14 service manual), I found out that this is a pretty ingenious method of cleaning the air in the tractor's intake tract.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.