Posted by mech on September 18, 2013 at 23:43:39 from (22.214.171.124):
I have a question on the subject of hydraulic cylinders, where I have a hydraulic cylinder and I want to replace all the oil seals , but, when i disassembly the hydraulic cylinder and the gland , i found inside the gland oil seal and backup ring together, since , the back up ring is solid (uncut) (none split) and is placed inside the seal as show in the picture above , since this seals and backup ring is placed inside the gland which is have internally grooved , so , my question is :
1- how can i installed this back up ring inside the gland ?
2- is this seal and back up ring is installed together or each one separately ?
3- if i want to cut this back up ring at 30 degree , are there problem or not ? I mean is this correct or not ?
4- if i want to warm the back up ring in the hot water and then put it inside the seals directly , and then installed it together inside the gland , are there problem or not ? I mean is this correct or not ?
5- if i want put the back up ring inside the seal and shaped it together as kidney shape and then installed it inside the gland , is the back up ring is broken during the formed it or no ?
the attach file above is indicate the seal and back up ring
i will wait your help to answer me dear
This post was edited by mech at 23:48:32 09/18/13.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.