Posted by george tegeler on September 18, 2013 at 08:12:52 from (207.32.17.141):
In Reply to: Looking For? posted by L.B, on September 13, 2013 at 16:16:34:
I recently acquired an 8n with an under-drive. The tractor wouldn't go into 2nd gear. In researching I found that I have a Howard. The Howard has a cut-out on the side for the 2nd/4th shift fork shaft to slide into. This is all aft of the trans housing. I split the rear-end away & found the cut-away was not quite right & the fork shaft would contact the Howard thus not allowing it to go into 2nd. A couple minuets with a die grinder fixed it. I guess 2nd gear hasn't worked since the howard was installed decades ago.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.