Posted by Acadianbob on August 23, 2013 at 09:01:54 from (22.214.171.124):
OK, this ought to be simple. I bought a new gas shutoff valve and a new pre-bent fuel line for my 8N; the old valve was shot and the old fuel line had a bad crimp in it. I replaced the old with new and now have a considerable gas leak where the fuel line goes into the brass inlet/filter at the carb. I have the line as "straight" and "lined up" as I can. The plug into the carb is tight (and not cross-threaded). But I have a bad leak. I even used some pipe thread compound on the plug. The leak appears to come up the threads of the plug; and not between the fuel line and the plug.
Is it possible that I need to replace the brass inlet on the carb? I"m wondering if anyone else has run into this issue and solved it.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.