Hopefully we can get it done. What is the correct best seal to get? On a positive note some may remember I said it had no 2nd or 4th gear when shifting. Someone had bent the shift fork so it was impossible to use those gears. Removed it bent it back and have all 4 gears again. Hoe response is so much better also now that the white/caramel colored watery hydro fluid is gone in tank. Tranny fluid was awful also. Rear end had about a quart of what looked like used motor oil in it. . Certainly not 8quarts of anything! Some dipstick also swapped top covers so there was no fill place for the sump except beings the quadrant was not in place allowing water in we filled through there and will plug that hole and use as a fill spot. Odd thing clutch still worked great although oil soaked.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.