Sounds like the tail wheel vertical shaft is froze up. Usually caused by dried grease and dust inside and grease fitting plugged, not allowing you to get grease in "Zerk". You need to do 2 things. One get the wheel freed up. With the tail wheel off the ground, remove the cap (probably held in with a cotter key) and spray with WD 40 or PB blaster, or ATF, or oil and try to turn it left to right. May have to let it soak 24 hours. May end up having to heat it. Second thing is to try and grease using a grease gun on the grease zirk. If it doesn"t take grease, you may have to screw it out and clean both the zirk and in the fitting to the shaft and also also spray thru the hole. Grease should be able to come thru the zirk, when snapped on the grease gun, before putting back on. Are you also using the depth control lever (8N and above) to hold the front of the chopper up, or using depth chains. failure to have this right can cause undo pressure on the rear tail wheel. The side skids should be off the ground. Charles Krammin SW MI
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.