Posted by billy boy2 on May 13, 2013 at 12:16:56 from (72.251.10.174):
In Reply to: Position Control posted by JMOR on May 13, 2013 at 09:52:54:
Quoting Removed, click Modern View to see
Ok. When I started, with the lever set to draft, I had movement of the lift arms as soon as I moved the control as if it were set to position control. There was no control of the position in this setting,but the lift arms would stop on the way up and go back down if I moved the control to lower them. I could almost get them to stop in positions,as you can by kind of feathering the control. If I moved the control all the way up, the arms would raise, what looked like too high compared to my others, and would act as if it was trying to raise them even higher,as in I could hear the pump laboring. Moving the quadrant position back made it worse. I didn't even have to raise the control to the top, to get it to go too high,and try to go farther. By the time I adjusted the quadrant all the way forward in small increments, (sp?)testing each time, I got the draft control to only work in the last 2 inches of movement of the control lever, and stop at a reasonable height, without continuing to labor the pump. So all seems good on the draft.
On position control,my control lever all the way down, it holds a box blade about 5" off the ground. Metal to metal solid holding. Positions change higher as they should as I raise and loweras I lower the control, but stops dead with the lower lift arms holding my blade off the ground 5-6".
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oil Bath Air Filters - by Chris Pratt. Some of us grew up thinking that an air filter was a paper thing that allowed air to pass while trapping dirt particles of a particles of a certain size. What a surprise to open up your first old tractor's air filter case and find a can that appears to be filled with the scrap metal swept from around a machine shop metal lathe. To top that off, you have a cup with oil in it ("why would you want to lubricate your carburetor?"). On closer examination (and some reading in a AC D-14 service manual), I found out that this is a pretty ingenious method of cleaning the air in the tractor's intake tract.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
