Posted by redjohn on March 03, 2013 at 04:13:31 from (74.33.91.75):
In Reply to: No governor control posted by notjustair on March 02, 2013 at 20:30:39:
The linkage is hooked up correctly. The throttle lever shaft is hooked to the governor lever, and the other rod goes from the governor lever, to the carb. According to the manual, I'm supposed to pull the throttle lever to wide open (with rod to carb disconnected) then holding the carb throttle plate wide open, the snap on connector from the governor rod, should line up with the ball on the carb linkage, and clip right on.
There was some concern as to the governor assembly slipping on the crankshaft, (as there are no teeth inside the tube) but when we loosened the balancer pulley, it was on very tight.
Could this be an issue where it is slipping on the crank? If so would adding shims behind or in front of the governor work? Thickness of shims?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oil Bath Air Filters - by Chris Pratt. Some of us grew up thinking that an air filter was a paper thing that allowed air to pass while trapping dirt particles of a particles of a certain size. What a surprise to open up your first old tractor's air filter case and find a can that appears to be filled with the scrap metal swept from around a machine shop metal lathe. To top that off, you have a cup with oil in it ("why would you want to lubricate your carburetor?"). On closer examination (and some reading in a AC D-14 service manual), I found out that this is a pretty ingenious method of cleaning the air in the tractor's intake tract.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.