Someone sent Gary one with a plug in that location about 3 years ago. I do not recall anything being said about it being drilled all the way through into the venturi. If that were actually done, as described here, then the pressure balance of the carb would be terribly upset as the space surrounding the venturi (that is, space between cast wall with plug & the venturi) is normally at vent pressure (same as intake opening), whereas as the inside of venturi is lower pressure generated as a result if air flow through the venturi. If those were ported together as this suggest, then the carb would not function or would function so poorly that the tractor would be unusable. You can demonstrate this effect by installing the venturi upside down such that it will not seal at the ends, as has been done unintentionally by persons in the past. Makes no sense why anyone would drill all the way through into the venturi itself. Especially, leaving the vent to inside venturi connection. Are you sure there was not a tube sealing into the venturi & simply passing through the space between the wall & venturi? This would be a very different matter, as then the two different pressure areas would not be connected to one another.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.