Posted by Dell (WA) on January 09, 2013 at 20:55:48 from (71.217.23.84):
In Reply to: Need wireing help posted by Brian Livingstone on January 09, 2013 at 17:17:14:
Brian........you write......"The solinoid is marked where the battery lead connects one one side. It also shows a white wire going from the switch to the small lead on the solinoid but I can't understand why" ........ONLY the 8N had 3-terminal starter mounted solenoid. The 9N/2N has a roundcan voltage regulator under the battery tray that many neubie shadetree mechanics might mistake for a solenoid. Most likely, the white wire is providing power to the ignition switch and thru the "infamous ballast resistor" to the top terminal of the 4-nipple squarecan ignition coil. .........Dell, a 12-volt advocate for the right reasons, who knows 8-ways to convert to 12-volts and they all work the first time
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.