Posted by soundguy on December 31, 2012 at 20:27:54 from (184.246.105.157):
In Reply to: Voltage reducing posted by Notjustair on December 31, 2012 at 20:19:03:
won't work,
voltage reduction via a resistor will be based on load.
your coil and your lamp assy are NOT the same load.
if you have a front mount and the oe coil.. you need the oe resistor and a proper converting resistor to drop primary current to a max of 4a.
if you are sidemount and oe coil.. then just the resistor.
me? i'd squander the 35$ and get 3 new lamps and a new coil if sidemount.. if front mount.. tat will be about 45$.
otherwise, if you can do without a tail lamp, you can open upt he 2 front lamp shells and wire the front lamps in series and run them that way.. when one pops you lose both as it breaks the circuit.
you've spent 'this much' so far. go ahead and finish it off and not have to worry about it.
the resistor and coil, vs new coil isn't the issue. the lamps are the issue.. you won't be happy trying to come up with a fixed resistance to run them correctly..
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.