Posted by Berghandler on December 30, 2012 at 06:39:42 from (66.192.73.89):
I had been having problems getting my 1949 8N starter to always engage. I noticed that it would jump or skip a beat when cranking like some teeth were maybe broken in the ring gear. I asked local dealer and he recommended a new bendix. I installed one and even though it turned over and started better it made the skipping spot now like a pounding, on the ring gear I think. SO much so that now the starter just spins and NO engagement or turn over of engine. I think I either am at a spot on the ring gear that truely has no teeth left or I've broken teeth on the bendix, or pin has come out and bendix is no operational. I have turned over engine by hand in an atttempt to get to a new spot on the ring gear and then tried to start again but always the same result, starter just spins. I think I need to check out ring gear but that looks like a major project especially if it needs to be replaced. Any ideas? If it needs a new ring gear is there any easy way to replece other then having to crack the engine from the frame?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.