Before the starter locked up and I replaced with new starter and solenoid, all of the wiring was correct from ammeter, ignition, push button, and starter. I swapped everything out and wasn"t sure about the wire from key ignition switch going to right side of solenoid cause all the diagrams didn"t show it that way. Dell confirmed that it was ok to run that way. So it looks like everything is back where it was before starter crapped out. I"m hopping the reason I"m only getting a "click" is due to bad battery, but I"m afraid it may be a bad new solenoid. Heading to get battery checked now. I"ll keep you posted. Thanks for your help and patience.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.